furniture the hands how to make furniture the hands furniture the hands - the main page the main page - furniture the hands furniture manufacturing by the hands furniture manufacturing by own strength
offers on furniture manufacturing by the hands how to make furniture the hands furniture the hands, articles furniture the hands, councils recommendations how to make furniture the hands councils how to make furniture the hands furniture the hands a management how to make furniture the hands

When the useless space becomes useful

In many apartments corridors do not come to an end with last lateral dvermi, and proceed slightly further. Usually, mainly in new apartments, this piece separates from other part of a corridor a partition with a door. Such premises name podsobkami. Frequently them use as a closet and hold in them the most different things. However who to us prevents to convert in appropriate way this site of a corridor and to issue it so that it was possible to expose different subjects for a general review, but also to equip behind a curtain a locker room which can use and visitors of the house?

If you have ventured this re-equipment, first of all it is necessary to take measurements, to estimate the sizes of that we are going to build and we will operate further already on the basis of the concrete sizes. We take, for example, the variant where the width of a premise will be 140 sm, of 180 sm and height - 250 see length - In the beginning we will close (if is) pipes which very much disturb, settling down as a rule near to an input. For this purpose we take two frames which occupy the corresponding width and block a proper place from a floor to a ceiling. We sheathe these frames a firm wood-fiber plate and we paint or we cover with wall-paper according to the registration of a premise chosen by us. .

Now we are accepted to the equipment of a back part of a corridor, and also the mezzanines located sideways. It is for this purpose made two frames in width 6о sm and in height 190 They see 6-8 sm lapped consist from reek in the thickness 2см and width. For bolshej durabilities we will supply frames still a minimum with three cross-beams. One of two frames privertyvaetsja screws to a wall (in a back corner), through preliminary inserted into it plastic shkanty, another strongly incorporates to plug-in regiments in width of 50-60 sm which on either side of are on bearing rejkah, privernutyh screws to an inside of frames. .

Thus at us the design like a case where it is possible to hold the most various subjects, and simultaneously an angular support for mezzanines turns out. In a direction to the basic part of a corridor our case is revetted with a firm wood-fiber plate, and on it, accordingly opposite to it, on a lateral wall of a room fixing devices where the piece of a thick wooden bar or a metal pipe on which a coat hanger for outer clothing is hung up becomes stronger are equipped. .

Mezzanines are equipped as follows. Back have a support at the left on a case, and on the right - on thick, attached to a wall on shkantah rejke; they consist of the boards laid densely to each other and fastened by nails (thickness approximately 2 sm). The left mezzanines (depth approximately 35-40 sm) are under construction in the same way, and boards have a support on rejke, on a wall where there is a door. Behind they keep within over boards of cross-section mezzanines to a back wall. From below these regiments also are sheathed by a firm wood-fiber plate. .

On a ceiling and under cross-section mezzanines boards with devices take places For zadrapirovki curtains before which eaves are nailed up. A role Hangers carry out three inserted into a wall on shkantah cross-section boards, on which privertyvajutsja screws vertically located boards supplied with a coat hanger For outer clothing. All design is covered from above with a cross-section board for Caps and hats. On an opposite side on a wall the mirror, and under it is hung up The shelf having the form of a low long box takes places. Over a mirror it is possible to establish Luminescent lamp shining all premise. .

As one more possibility we will imagine earlier offered division of a back wall in "чхЁърыіэюь" a variant. Differently the big right part all becomes the big hanger, and it is necessary to equip from above only the device for zadergivanija a continuous curtain. Besides it is possible to hang certainly dverki on all case at a back wall or on its part. In this case on a wall and below at a floor it is possible to establish corresponding persistent laths.
As one more possibility we will imagine earlier offered division of a back wall in "чхЁърыіэюь" a variant. Differently the big right part all becomes the big hanger, and it is necessary to equip from above only the device for zadergivanija a continuous curtain. Besides it is possible to hang certainly dverki on all case at a back wall or on its part. In this case on a wall and below at a floor it is possible to establish corresponding persistent laths.