the Garden - desired vacation spot for the person. It should help to the person to relax and should be simultaneously equipped is practical and it is convenient. Therefore in the given section it will be a question of active use of one of lawn sites, creation on it of a rest zone, and without any considerable material inputs, and at the same time keeping it.
Fruit-trees cannot create a uniform shade, therefore we suggest to create its artificial means, guaranteeing that the grass of the closed site of a lawn will be still green and magnificent. To put it briefly, it is a question of the equipment of a sun-protection canopy under which it is possible to put the big table with convenient summer armchairs, and chaise lounges. .
The Basic skeleton of a canopy consists of four beams or - as is given in our variant - from columns in diameter approximately 15 the Height in light as experts speak see, makes 200-220 the Sizes see depend on that area which we wish to close a canopy, however the distance between vertical racks should not be more than 3-3,5 m. frame Connection in a rectangle is carried out by beams (15 x 15 sm) in a diameter. The roof is made from roofing reek which distance from each other depends on width of mats of a canopy. .
When we collect in one place a material for processing and, according to the set sizes, we cut off it, connection of details from wood with each other first of all is carried out. In connecting beams thorns are cut out, and in columns eyes are hollowed out. Roofing rejki similarly incorporate on a thorn to cross-section beams or are beaten outside through beams by the big nails in end faces (thus it is necessary to watch that wood has not broken up).
After necessary working processes are finished, vertical columns are inserted into holes in advance dug out in the earth and fixed in them. If there is a possibility, in the beginning iron pipes and basic vertical columns are driven in the earth inserted into them. In any case the hole should be enough deep. At canopy height 2с superfluous metre it is necessary, that depth of a hole was a minimum 60-80 see .
Before establishing columns, it is necessary to process them protivognilostnym structure.
The Earth round columns should be imposed by stones and is stamped, and then preliminary removed turf should be put again back.
The Design of a roof of a canopy is established from above and fixed by slantwise driven in nails.
Over beams and roofing reek we unroll two or three (depending on the sizes) mats. On the one hand they are strongly fixed on brackets, and on the other hand, according to the longitudinal parties keep on taken out brackets which are inserted into preliminary drilled apertures. Taken out brackets should sit strongly, but easily be taken out, that through certain time intervals to curtail mats, substituting a lawn under solar beams. .
To give to all design especially an original form, we use a wood waste, is better pieces of trunks of the different sizes. They are inserted into the earth on some distance from columns which hold a canopy roof. On these pieces clay bowls with plants or the big pots with flowers which are strongly fastened to trunks by means of screws from soft metals are put. The earths to fill bowls and pots, in a garden, certainly, it is enough, and the choice of plants is carried out according to your desire, and it is better to have twisted and bushy plants so that they created a harmonious picture. .
Such flower ensemble at vacation spot in a garden looks very effectively if bowl to paint in white colour.
| the Canopy can be closed also motley marquisette, or a similar fabric which will hang down from roof edges. In this case for material fastening it is necessary to provide corresponding rings.