furniture the hands how to make furniture the hands furniture the hands - the main page the main page - furniture the hands furniture manufacturing by the hands furniture manufacturing by own strength
offers on furniture manufacturing by the hands how to make furniture the hands furniture the hands, articles furniture the hands, councils recommendations how to make furniture the hands councils how to make furniture the hands furniture the hands a management how to make furniture the hands

Successful addition to a furniture wall

When speak about the compelled completion of an existing blank, usually there is a sensation that we deal with something an invaluable, any second-grade substitute. However in our case "чрьхэш=хыі" is a beautiful finale at the equipment if not all your room, at least, the furniture wall which are in it. It is a question of filling of empty space between a furniture wall and a room wall. The place equipped before it for a dream is continuation of the expedient decision of a problem of filling of empty space at a wall. Thus the room area is used with the maximum return.

The Basic condition of good appearance of a self-made locker inserted by us is that it precisely corresponds to the sizes necessary for filling of the existing pier. In this case the locker is harmoniously entered in the general atmosphere of a room. .

The Locker consists of the several open shelves located over the closed bottom part which is simultaneously a curbstone for storage of bedding. The width of this locker - approximately 90 sm, depth of the bottom part, as well as all wall - approximately 6о sm, and depth of the top part (shelves) - approximately 40 see

As a material we apply: for the top part - pine or fur-tree boards, for the bottom part - rejki in the thickness a minimum of 2 sm and width - 6 sm of which first of all we do two frames forming lateral walls. In front, behind, from above and from below they incorporate rejkami an identical thickness as box connections, and they are linked or lapped by the ends. As the bottom part of a case takes up considerable cargo, it is expedient to cut cross-section connections so that they created a reliable support to all construction. All connections stick together and besides it are strongly fastened by nails or screws. .

The shelf is inside inserted Into this box frame from thin boards of a firm wood-fiber plate (TDVP) or plywood. A support for a shelf are located around, planted on pins rejki. If the wall has a socle the corresponding socle (a bit receding back), is glued and under the bottom part of a locker. The box for storage of bedding is outside revetted from all four parties with a firm wood-fiber plate or plywood. On the forward party of a box below we bore through the big apertures providing the best air circulation for bedding stored in it in a covering. From above the box is covered with a thick plate. It is divided in such a manner that the back part strongly incorporates to the frames located behind with the help shkantov, and the lobby serves as a leaning back cover. .

The Top part of a case how you are going to divide it, is equipped with corresponding quantity of cross-section shelves.

In the second example it is recommended to make a small cross-section shelf in a headboard of a place for a dream. It is simultaneously an original partition and a binding element between a wall and a bed. The design consists of a plate, a short cross-section shelf and two vertical partitions. As a material we use drevesnostruzhechnye plates (DSP), a plywood plate or the stuck together boards. .

The Thickness of a material should correspond whenever possible to a material, from which The wall is made. For a cross-section shelf we choose width approximately 30 Its Height see depends on a bed and is final from a box of a wall which is Strong support for a back part of a plate. The sizes of a small shelf are defined by that, How many places need to be left, that dverka walls below, under a shelf cover could To open. .