furniture the hands how to make furniture the hands furniture the hands - the main page the main page - furniture the hands furniture manufacturing by the hands furniture manufacturing by own strength
offers on furniture manufacturing by the hands how to make furniture the hands furniture the hands, articles furniture the hands, councils recommendations how to make furniture the hands councils how to make furniture the hands furniture the hands a management how to make furniture the hands

When splinters bring pleasure

It is said that the ware fights fortunately. However, when something breaks, we feel sensation of disappointment, rather than pleasures is more often. And nevertheless sometimes and splinters of the broken can give pleasure. For example, tile slices can give to your apartment unique, effective individuality.

To begin with, by means of tile slices it is possible to issue beautifully a small little table of a universal purpose, height approximately 50-b5 sm; the most common sizes of a table-top - 60 h 60 see Podstole becomes from two connected tsargami basic frames, each of which in turn consists of two reek (table legs) and one cross-beam. Legs and a cross-beam are connected among themselves by thorns. Thus legs are established naklonno so that in the bottom part the distance between them corresponds to width of a table (drawing at the upper left see). .

The Difference in thickness reek for legs and tsarg - 2-3 see In the top part connecting rejki three are pasted shkanta; apertures under shkanty are bored through from the bottom party of a table-top. Connection tsarg with legs is carried out similarly by means of two shkantov. As a material for a table-top are used plywood or pressshpan (thickness 2см) as ordinary wood is subject korobleniju therefore can suffer and a tiled covering. Precisely cut out and ostrugannaja the table-top is framed rejkami which are pasted or nailed up. The thickness reek - 0,5 - 1 cm, a depends width on a thickness of a table-top and a tile layer. .

When all joiner's works come to an end, the artwork begins. A tile break into slices of the set size. Slices stack on a table-top, considering not only their size, but also colour scale to receive as a result certain drawing. Simultaneously it is necessary to watch that the distance between separate slices did not exceed 2-3 mm. Tile slices by turns paste to a table-top universal glue, plentifully greasing them and densely pressing a hand. Next day it is possible to get mixed up dense plaster kashitsu and to water with it all surface of a table-top. Then by means of a ridge sponge it is necessary to distribute plaster so that it has filled all grooves between tile slices therefore the equal surface should turn out. .

During hardening the appeared roughnesses can be smoothed, moistening a sponge with water. After plaster will harden, it is necessary to polish only a surface with a dry napkin, and our tiled little table is ready. This method is used and for other subjects about which we will tell more low. By means of tile slices it is possible to make a magnificent, effective frame for a mirror in a corridor or a bathroom. The basis of this frame is made by an ordinary frame, on an internal and which outer side fasten on pins rejki various width. It is possible to make one more or several shelves of the material rests (with a fringing metal laths available on sale) which by means of a cord or a wire become stronger on a wall and in a combination to a mirror frame form uniform ensemble. .

The Third example of expedient use of slices of a tile are boxes for colours.

The Wooden basis of boxes is made of boards in the thickness 1,5-2 see As is specified in our drawing, two continuous lateral boards, two short cross-beams, a board approaching in the sizes are for this purpose applied to a box bottom (with preliminary drilled apertures for ventilation) and two rejki, enclosed under a box. The box size depends on an available place, however in any case the box should be rather small as it is necessary to consider and its weight. .

Tile Gluing to be made in such sequence: in the beginning the face parties (zapodlitso with end faces of lateral boards, then the long parties and in summary the top edges).

ARE NECESSARY