furniture the hands how to make furniture the hands furniture the hands - the main page the main page - furniture the hands furniture manufacturing by the hands furniture manufacturing by own strength
offers on furniture manufacturing by the hands how to make furniture the hands furniture the hands, articles furniture the hands, councils recommendations how to make furniture the hands councils how to make furniture the hands furniture the hands a management how to make furniture the hands

the Cosy islet in the big room

the Following example of re-equipment of apartment concerns only the big premises. In old areas of cities there are many such rooms in which middle it is possible to equip freely a cosy islet where it is pleasant to sit, have a rest, have a talk.

The furniture Being here for sitting consists of five shelves and two sedentary places located at right angle to each other. On an outer side of shelves it is possible to place many books. The back party of shelves serves as a back and armrests for sedentary places. The average shelf acting as a corner can be equipped inside as a house bar. Thus, having occupied rather small area, we can use a spacious room in the best way. .

The Sizes of our construction are defined by dimensions of sedentary places which in turn depend on the sizes of pillows with porolonovoj, stuffing or the simple mattresses used for soft seats and having, as a rule, length of 90 sm and width 60см. The width of a pillow makes thereby depth of a sedentary place. Regiments have height 8о Lateral regiments see it is possible to make and more low. Then necessity for cross-section division will disappear, or separate sections will be much more low. The width of lateral shelves is a depth of a sedentary place, i.e. 6о the Length of back shelves see plus depth of lateral shelves to which back regiments incorporate at right angle is made of length of pillows (90 sm). The maximum depth of shelves should be no more than 25 the Thickness of the boards applied to shelves see, should be approximately 2 see .

The Best connection of parts of shelves is connection on shkantah where the bottom and average boards incorporate with bokovinami, and the top board incorporates with bokovinami shkantami from above. Besides under all regiments it is recommended to glue the basis in the thickness approximately 3-5 see As a back wall behind privertyvaetsja screws or the firm wood-fiber plate (TDVP) or if is available, plywood is nailed up. Separate sections of shelves should be connected in convenient places screws that the steady block was formed. At repair all can be disassembled easily. .

The Average shelf has two walls converging at an acute angle. This triangular shelf precisely entering into a corner between sedentary places as well as other regiments consists of the bottom, average and top boards. Behind them the back wall therefore the angular branch which as it is specified in the bottom drawing, having supplied with corresponding holders is formed takes places, it is possible to use for placing of bottles and glasses. Means that preliminary on rejkah the shelf is established. The leaning back cover fastens by means of the hinge to the top plate. Sedentary places become taking into account the sizes of pillows for sitting, in the form of frames to which across nail up boards in the thickness approximately 1,5 we see In front we close these frames a thin board that pillows did not slide off, and strongly we connect their screws to regiments. The sitting height should be approximately 40 see .

As backs headrests available on sale which the same as pillows for sitting, it is necessary to fit a decorative material are used.

If in the same premise the couch the part of back shelves can be used not for books, and for bed-clothes placing is established. For this purpose the bottom part of shelves is outside closed by a plate, and the top half - a leaning back cover. Apertures in a shelf in diameter of 2-3 sm promote the best air circulation. .

the House bar (drawing at the left see) is recommended to be sheathed from below plastic. Holders for bottles and glasses it is possible to make of wood or a metal waste. In any case it is necessary to provide, that glasses settled down reliably and could not fall.
the House bar (drawing at the left see) is recommended to be sheathed from below plastic. Holders for bottles and glasses it is possible to make of wood or a metal waste. In any case it is necessary to provide, that glasses settled down reliably and could not fall.

ARE NECESSARY